CALL NOWCALL NOWCALL NOWGATEWAY SELECTORCALL NOWGATEWAY SELECTORLEARN MORELEARN MORE PROCEED TO CHECK-OUT SUBSCRIBE TO OUR RSS FEED SEARCH GATEWAYS NOW SEND MESSAGE NEWSLETTER | SUBSCRIBESUBMIT CALL NOWCALL NOWCALL NOWGATEWAY SELECTORCALL NOWGATEWAY SELECTORLEARN MORELEARN MORE PROCEED TO CHECK-OUT SUBSCRIBE TO OUR RSS FEED SEARCH GATEWAYS NOW SEND MESSAGE NEWSLETTER | SUBSCRIBESUBMIT

GE Fanuc Gateways


There are two ways we can help you with Ge Fanuc PLC’s and drives. Firstly we can help you connect foreign systems to your GE equipment and PLC. We can help you connect systems fire alarm systems, gas sensors, HVAC equipment, building automation systems etc. This way you can use your PLC’s to control and monitor these devices without having to implement a hard wired solution. Secondly we can help your control or building automation system monitor and control data in an GE Fanuc PLC. In both modes our gateway can act as a client and server or combination. GE data can be read and written.

Convert

We have module solutions which allow integration directly into GE Fanuc products as well as the stand alone solutions shown bottom right.

Range of Conversation Solutions

Depending on project requirements select from units with varying resources. and multi port devices. OEM and embedded solutions too.

QuickServer 10102x RS4851x Ethernet
QuickServer 10111x RS4851x Ethernet1x Lonworks
QuickServer 12101x RS485 1xRS2321x Ethernet
QuickServer 12111x RS485 1xRS2321x Ethernet1x Lonworks
QuickServer Fieldbus1x RS4851x EthernetM-bus or KNX
FS20 Series1x RS232/4851x Ethernet1x Lonworks
FS25 Series2x RS232/4851x Ethernet
FS30 Series2x RS232 and 2x RS4852x Ethernet1x LonworksFieldBus Support:eg Profibus, DeviceNet etcHot Standby Support
FS40 Series8x RS232 and 2x RS4852x Ethernet1x LonworksFieldBus Support: eg DH+, MB+, Profibus, DeviceNet etcHot Standby Support
SlotServer1x RS232/4851x Ethernet1x LonworksFor Rockwell ControlLogix 5600

Lonworks and Fieldbus are options not provided on base models.

Block Diagram

FS30 series shown for purposes of illustration. Capability depends on hardware, firmware and configuration.

Chipkin Automation and GE Fanuc

These drivers were developed by Chipkin Automation Systems for FST. We know the GE protocols to source code level and provide 2nd tier support to FST. Get expert support and configuration from day 1 with Chipkin Automation Systems.

Need Help

GE Fanuc Web Site: www.gefanuc.com

Need more info ? Call or email us.

Metasys® as used in this document is a trademark of Johnson Controls, Inc

Gateway Selector

Select your combination of protocols.
Protocol 1
Protocol 2

Contact Us

Contact us via phone (+1 866-383-1657) or leave a detailed message below for sales, support, or any other needs

*Required Field
I'd like to receive the newsletter. *Check email for confirmation.
*Required Field
Preferred Time To Be Contacted (PST)
8:00am - 12:00pm 12:00pm - 5:00pm