Articles Directory : Explore Our Publications Page 52

Back to Main Article: Notifier Fire Alarm Panel Integration Solutions…

TAC-I/Net to BACnet Gateway This technical note details the s…

Printing and saving a Veeder-Root setup report is a critical step after completing configuration of a TLS-300 or TLS-350 automatic tank gauge (ATG) s…

RS485 needs 3 conductors and a shield. Many people say it's a two-wire network but it is not. Two conductors are used to carry the RS485 Differential…

EIA-485 (formerly RS-485 or RS485) is a specification for the physical layer of a network that uses the difference in voltages between two wires (Three wire) to conveys data. One polari…

The RS-232 Mini Tester is an efficient device to connect in series with any RS-232 interface for testing a serial (RS-232) link. An example of how an RS-232 mini tester looks like is shown in figure-1…

FieldServer FS20 Series: Connecting to ICD102A Optical Isolator via 2-Wire RS485 This article shows a simple, practical wiring approach for connecting a FieldServer FS20…

USB-COMI-SI-M – USB-to-Optically Isolated RS-422/485 Adapter The USB-COMI-SI-M is a USB-to-serial adapter that provides a reliable, optically isolated interface f…

I was asked this question today,What would happen if you had two BACnet MSTP devices with different MAC addresses but the same BACnet Device ID (Node ID) on the same network, and you sent a Broadcast…

DO NOT USE THIS DATA – IT IS SUBJECT TO CHANGE AND IS PROVIDED FOR REFERENCE ONLY. The points listed and the Lonworks addresses allocated are typical. We strongly advise you not to hand…

Convert We have module solutions which allow integration directly into Modbus TCP as well as the stand-alone solutions shown bottom right. Range of Conversion Solutions We know that project require…

Modbus TCP is a member of the Modicon Modbus family of protocols and is designed to operate over standard Ethernet networks using the TCP/IP transport layer. It extends…